Vessel Guide

Models › Bristol

Bristol 32

Built 1966–1983 by Bristol Yachts

Is she right for you? Take the quiz Own one? Start her custom manual Looking at one? Sea-trial scorecard

About the Bristol 32

Researched from public sources for this model. Any individual boat may have been modified or repowered — confirm before relying on any figure.

Illustration of a Bristol 32
Illustration, not a photo of this model. AI-generated illustration of a typical mid-size cruising sloop.
Built
1966–1983
Builder
Bristol Yachts
Designer
Ted Hood
Length
32 ft
Waterline
22 ft
Beam
9.5 ft
Draft
4.67 ft
Displacement
10,800 lb
Ballast
3,900 lb
Hull
fiberglass
Rig
sloop
Propulsion
inboard
Fuel
25 gal
Water
100 gal
Water heater
not fitted
Number built
322
Stern thruster
not fitted
Steering
varies by year
Tank capacities — where the figures come from
  • Fuel 25 gal
    Spec databases repeat 25 US gal (95 L) with the Atomic 4. An owner's ad for a 1975 boat says 17 gal, but that's one boat, possibly re-engined (another 1975 listing has a Bukh diesel), so it can't change the figure. No brochure was found.
  • Water 100 gal
    Two 1975 listings stress 100 gal of water, one noting it isn't a typo, matching the spec figure; another spec database gives 90 gal. There's no builder source.
  • Water heater not fitted
    “For a seeker of creature comforts, hot and cold pressure water for instance, the Bristol 32 might not be a good fit, unl” — review, goodoldboat.com
    Good Old Boat's review says the Bristol 32 did not come with hot and cold pressure water; any heater aboard would be an owner addition. No builder document found.

Tanks are often replaced or added on older boats — check the tank labels or a survey for yours.

Thrusters and steering — where this comes from
  • Stern thruster not fitted
    Our earlier figure of none has no source, and nothing was found either way.
  • Steering varies by year
    “Bristol 32s were built with either wheel steering, in which case the mainsheet traveler is located immediately in front” — review, goodoldboat.com · “Early boats had tiller steering and primary winches bolted forward on the coaming. On wheel-steered versions, the winche” — spec database, listingsport.com
    Built with either tiller or pedestal wheel steering; one secondary source says early boats had tillers. No source found gives the changeover year, which was standard, or the wheel's mechanism and brand.

Thrusters and steering are often replaced — check the units on your boat before ordering parts.

Sources disagree on hull/keel type — left blank rather than guessed.

Ted Hood design (sailboatdata also credits Dieter Empacher). Offered as sloop, yawl or ketch, with a tall-rig sloop option. Keel/centerboard version draws 3.5 ft board up, 7.5 ft down. Sailboatdata lists the hull type as modified full keel but its notes also mention a fin keel; Good Old Boat calls it a full-keel CCA-style cruiser. Deck bonded to a 6-7 in. inward hull flange. Can hobbyhorse in light wind or a sloppy sea.

Engines fitted

Generator

No source mentions a generator.

Known problems for this model

Engines & parts

Universal Atomic 4 parts: good

Factory standard engine — you entered “Atomic 4 (Universal)”

Tens of thousands were built (sources say from 40,000 to 50,000). Despite being out of production for decades, the engine is well supported: Moyer Marine sells parts, rebuilt engines, fuel pump rebuilds and exhaust parts, and hosts an owners' forum; Old Lyme Marina and others also supply parts, and electronic ignition upgrades are available.

Parts sources: Moyer Marine

Common problems (3)
  • Raw-water cooling scale and corrosion cooling
    Most Atomic 4s are raw-water cooled, so the block scales up and corrodes, especially in salt water; cranking without starting can also flood the engine with seawater through the exhaust.
    goodoldboat.com · moyermarineforum.com · keelindex.com
  • Gasoline vapor fire/explosion risk fuel
    Gasoline vapor is heavier than air and settles in the bilge, so ventilation, blower use and shutting the fuel valve (a stuck carburetor float can overflow) matter.
    goodoldboat.com
  • Ignition and fuel system faults electrical
    Points, condenser, cap and wires, plus gummed carburetors and contaminated fuel, are the most common reasons an Atomic 4 won't run well.
    keelindex.com · goodoldboat.com
Maker’s service schedule (9)
Engine oil & filter change50 hrs
“3. FIFTY HOUR CHECK a. Using sump pump, remove all oil from crankcase. Refill with a good grade oil as specified in Tabl” — manufacturer, westerbeke.com
Fuel filters & water separator50 hrs
“e. Clean fuel pump strainer.” — manufacturer, westerbeke.com
Heat exchanger & oil cooler cleaning50 hrs
“b. Inspect oil cooler and remove any accumulation of grit or dirt.” — manufacturer, westerbeke.com
Clean flame arrestor100 hrs
“b. Inspect flame arrestor to be sure air passages are clean and free from oil. If dirty remove and wash with kerosene.” — manufacturer, westerbeke.com
Check clutch (reverse gear) adjustment100 hrs
“4. ONE HUNDRED HOUR CHECK ... c. Check adjustment of clutch.” — manufacturer, westerbeke.com
Valve clearance check / adjust150 hrs or 1 yr
“5. ONE HUNDRED FIFTY HOUR CHECK a. Check valve tappet adjustment.” — manufacturer, westerbeke.com
Spark plugs inspect / replace150 hrs
“b. Remove, clean, and reset spark plugs.” — manufacturer, westerbeke.com
Transmission fluid change
Universal V-drive unit (V-drive installations only; the standard reverse gear shares engine oil)
500 hrs
“(2) After the first 50 hours of operation, drain unit and refill ... (3) Change lubricant every 500 hours of operation.” — manufacturer, westerbeke.com
Complete overhaul3,000 hrs
“At the end of three thousand hours of operation the engine should be completely overhauled.” — manufacturer, westerbeke.com
Service part numbers (8)
Oil filter
optional add-on oil filter (not standard equipment)
Universal 276236
“2 Element or Cartridge 1 276236 (Oil Group, Oil Filter, Not Standard Equipment)” — manufacturer, westerbeke.com
Raw-water impeller
Oberdorfer N202M-03 / N202M-07 replacement raw-water pump (Universal pump 295625)
Oberdorfer 6593
“5 Impeller 6593 6593 6593 6593 6593 1 (N202M, N202M-03, N202M-07 parts list)” — manufacturer, pumpsandpartsonline.com · “Impeller : Catalog # 6593, Impeller” — dealer, pumpagents.com
Raw-water pump kit
Oberdorfer N202M-03 / N202M-07 raw-water pump
Oberdorfer 10725
“REPAIR KIT N202M N202M-03 N202M-07 10725” — manufacturer, pumpsandpartsonline.com · “Catalog # 10725, Repair Kit, includes O-Ring, Snap Ring, Impeller, 2 x Lip Seal” — dealer, pumpagents.com
Drive belt
alternator belt (Prestolite and Motorola alternators)
Universal 239387
“19 Belt 1 239387 (12 Volt - Motorola 51 Amp Alternator)” — manufacturer, westerbeke.com
Spark plug Universal 273276 × 4
“8 Spark plugs, champion 4 273276” — manufacturer, westerbeke.com
Thermostat
late style, from 1967 / serial #79476 (Holley 145 F, on cylinder head)
Universal 200206
“12 Thermostat Kit 1 200206 consists of 262278 and 261601” — manufacturer, westerbeke.com
Thermostat
Dole type, before serial #79476 (on manifold)
Universal 200207
“13 Kit, Thermostat (consists of 275965 & 261144) 1 200207” — manufacturer, westerbeke.com
Zinc / anode
fresh-water-cooled engines only (Universal heat-exchanger kit)
Universal 299760
“23 zinc pencil 1 299760 (Cooling, Fresh Water System, after serial #79476)” — manufacturer, westerbeke.com

From the engine maker’s parts lists, or two independent parts dealers. Numbers change with serial number and get superseded — check yours before ordering.

Sources disagree on first year, last year, number built — left blank rather than guessed.

Model sources (3)

sailboatdata.com · goodoldboat.com · listingsport.com

Other Bristol models

Researched from public sources. Spotted an error? The sources are listed above — tell us what they got wrong.